F100 3.0.15 for MS-Windows and F100 Firmware 1.0.15

PC F100 changes since release 3.0.14

• Modified a behavior that caused problems when running multiple F110s/125s/165s on the same computer while a  USB driver reports hardware errors. In the past, when a hardware error was reported on the USB connection, F100 would switch to the next available generator automaticaly. This caused confusion and the behavior was modified to not automaticaly seek another generator and simply report a USB error message in the status field while running. This change only affects users running multiple generators on the same computer while the USB driver is reporting hardware errors. We had only one repport of such an error but changed the F100 behavior to avoid confusion in such cases. All other users will not be affected by this change. 

Firmware changes since release 1.0.14

• Modified the keypad behavior to allow the keypad to automaticaly reset itself whithin 5 seconds after a change in RF noise is detected. This is usefull for those running our generators with powerful plasma tubes that generate high RF interference. With this change, users no longer have to restart or wait long periods before using the keypad after the tube is turned off. All keys except the arrows and delete key will reset and respond within 5 seconds, The arrow keys will reset after 20 seconds and the delete key will reset after 15 seconds.